HVAC/R Sensors
Company Overview
Catalog/Price Book
Instruction Sheets
Ordering & Shipping
BAPI Distributor List
Contact Us
Building Automation Products, Inc.,
Tel: +1-608-735-4800
Fax: +1-608-735-4804
Copyright © 2007 BAPI
Analog Output Modules Wireless Sensors
All BAPI Analog Output Modules receive data from a 418 or 900 MHz Receiver through a four-wire bus. Up to 127 different Analog Output Modules can be connected to a single receiver to send multiple variables to the controller. Each module is easily trained to a single transmitter variable with a pushbutton and LED. Each module is surface, 2.75” snaptrack or 35mm din rail mountable.
| Resistance Output Module (ROM) The Resistance Output Module (ROM) converts the data from the Wireless Receiver into a Resistance for the DDC controller. The unit is factory calibrated to output a 10K-2 or 10K-3 thermistor curve. |
| Voltage Output Module (VOM) The Voltage Output Module (VOM) converts the data from the Wireless Receiver into a linear 0-5 volt or 0-10 volt signal for the DDC controller. |
| Current Output Module (COM) The Current Output Module (COM) converts the data from the Wireless Receiver into a linear 4-20 mA signal for the DDC controller. |
| Setpoint Output Module (SOM) The Setpoint Output Module (SOM) converts the Setpoint data from the Wireless Receiver into a Resistance, Voltage or Current for the DDC controller. |
| Relay Output Module (RYOM) The Relay Output Module (RYOM) converts the data from the Wireless Receiver into a floating switch closure for the DDC controller. |
|
|
Resistance Output Module
Voltage Output Module
Current Output Module
Setpoint Output Module
Relay Output Module